Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
So I have an express and it shows on the site that package isn't listed, is that because I would have to change features via ALFAOBD to tell my truck I'm running led lights so I don't get bulb out warnings?LUMENEX REVERSE LIGHT KIT 2100 LUMENS (Projector Headlight Ram) (7440)
(Sold As Set Of 2 Bulbs) This Kit is meant for the following Trim Level Ram Trucks 2013+ (Laramie) (Longhorn) (Sport) (Limited) Introduction: The Lumenex Reverse Light Kit is the brightest LED Reverse Light Option on the market today! Coming in at a staggering 2100 Lumens of output, puts these...dieselleds.com
Lumenex Cargo Light Set (1200 Lumens)
Created From Customer Demand For some time now our customers have asked if our Lumenex Reverse Kit could be installed in the cargo light housing and unfortunately we've always had to tell them, no they will not. However, to resolve this we've designed a set of Cargo Light that are almost as...dieselleds.com
Lumenex 3rd Brake Light (RED 600 Lumens)
Created From Customer Demand Our customers have asked for a 3rd brake light bulb as long as we've been in business, however we didn't want to offer one until it met the following two criteria. It coudn't cause bulb our errors (Most Non CanBus LEDs will cause brake light out error messages on the...dieselleds.com
All at once is over $100 but less than $100 each. I've got all these, and while I had a bit of sticker shock for 5 bulbs, once installed I was very glad I bought them. The reverse lights are nearly as bright as head lights. The cargo light and brake light are both great as well. All I've got left is fog lights to swap out then my truck will be all LED lights.
On a Regular cab there is no ignition switch in the door. The power is on all the time in the door. But on The Passenger side I have ignition powerMy handle controls already lit up from factory. I just kept trying combinations on the back of the plug that goes to those controls until I got the light to light up and push them down in and wrapped with some electrical tape. They turn on and off with the truck just like the lights for the power controls. Then used a dremel tool to put a clean looking hole in the handle bezel for the light to come through. Literally half hour job for both doors.
On a Regular cab there is no ignition switch in the door. The power is on all the time in the door. But on The Passenger side I have ignition power
Yea mine has a few more wires than that lolThere is only 3 wires going to the window switch
From eBay but now I see they only have a carbon fibre one. I found another one from WISH though.Nice Gregdad, where did you purchase the chrome piece.