Console swap help/question

[bjohnson3]

I came across and purchased a center console from LKQ. After getting home to my truck I realized there was an issue though, the one I received did not have the floor vent back piece or ac vent tube underneath. From all the diagrams I have seen I should be able to add/swap these pieces onto what I have instead of trying to sell and get another one. Anyone have experience with this or at least just knows the answer? Thanks!

 

[18harvest]

Those parts can be purchased new from mopar.the duct is like 110.00 not sure how much for the back piece.are you talking about the back cover piece that has the vents itself?Itself? If going from the jump seat there is a small duct that hooks the console duct to the main hvac duct also

 

[bjohnson3]

Yes, the piece that has the vents on it and the vent tube that goes the console. It looked like I could just order and add them just wasn't 100%. Do you happen to have a part number on the small piece?

 

[18harvest]

not right off hand but any mopar parts site has the parts diagram and it maybe in the common upgrades sticky in diy forum lots of numbers there.also the back piece center part that says ram is separate i think,its been a while but i think i had to order it also.does you truck already have the rear vents in the jump seat?if not the hvac main duct will have to be cut to add the floor vents.if it does just slip the small piece on.

 

[bjohnson3]

Yes, it does have the rear vents. That is why I am trying to make sure I can add the parts needed to the current console I have (no vents or ac tube). I will look into the upgrades area to try to find the answer. Thanks!