finally going to lower my truck tonight

[Lil Ram]

I have been waiting but I went ahead and pulled the trigger bought me a 2/4 drop. I have 20" stock rims and tires can I cut down to a 3/5-6 safelt

 

[delunad]

I'm sure you can without problems

 

[Lil Ram]

I just read the 1/2 off the front and 1.5 off the back. Do u know if I need to trim bump stops tho

 

[BlkRamRt]

yes you will need shorter bumpstops.

 

[Lil Ram]

I will post before and after pics hope all goes well

 

[UneasyJmitchell]

Are those factory stripes on your truck in orange?

 

[C3ntury]

If you stick with the 2/4 drop instead of cutting further, can you preease do me a favor and measure the front and back bottom fender to ground...if time allows

 

[Lil Ram]

If you stick with the 2/4 drop instead of cutting further, can you preease do me a favor and measure the front and back bottom fender to ground...if time allows

No I put the stripes...I use to have factory pinstripe painted along the sides but I removed them and put these on

Are those factory stripes on your truck in orange?

Ya for sure if I do just put the 2/4 I will get the measurement for u

 

[Lil Ram]

Lmao my bad swap the posts around for the correct one hahah wasn't paying attention

 

[Lil Ram]

I dropped my truck to a 3/5.5 after all and dam I'm glad I did it looks sick. And best of all "I have no wobble or rubbing what so ever"

 

[Lil Ram]

Here is how it came out..what y'all think

 

[DavidRam]

Looks awesome man! What kit did you use???

 

[C3ntury]

Nice stance. You end up cutting the 2/4?

 

[DERJ]

Looking sharp!
Did you use the Belltech and cut it?


Sent from my iPhone using Tapatalk

 

[mattmid101]

How does it ride? Would you be worried about towing anything?

 

[bigbadram1500]

Sweet. Looks nice

 

[Lil Ram]

The ride is good not bottom out or rubbing and I really don't tow anything but will try and see. And ya I bought the beltech kit 2/4 and cut it used the factory shocks but I will end up putting drop shocks later

And this morning I hit 110-115 on the way to work and no wobble at all and pretty good ride

 

[C3ntury]

I'm assuming that's what, about 10-11" from ground to bottom fenders( not guard)? Good to hear you have no "wobble-wobble."

 

[Twizzy228]

The lower you go, the better chance of eliminating the wobble.

Well done sir!

 

[Lil Ram]

Thanks and I will get measurements for y'all when I get a chance on a leveled surface but my rear is up I say about 1/2 more than the front. I will most likely level it later by cutting about 1/4-1/2 a coil turn more. But I have stock 33" tires and I will also b putiing about 29"-30" tires to bring it a bit lower