Hey all. I just got the FluxBeam X. I installed them last and while trying to adjust them the passenger side went out. I turned everything off and after about 10 minutes I tried again, it came on but it was very late so I turned all off and went to bed. In the morning I checked, it was on. I decided to check it first. Upon getting it all opened up I could smell burned stuff.
So it appears stuff got too hot and melted some wire cover. I have yet to reach out to Opt-7 as it is the weekend. So I have a 2017 Ram 1500 Express CC. Pretty much stock. I had talked with them before purchasing and they told me what I needed to buy. In that was I needed the TIPM bundle. In the instructions, it says if you have the TIPM bundle to start on Step 3:
Here is what my setup loos like connected.
I'm hoping I just got some bad parts that caused this and not that we have to stuff all that inside the housing and it just is not designed to. Does anyone else run these in a stock halogen housing? I did not get as far as to make a breather hole in the dust cap as they suggest, do any of you have that?
Sent from my iPad using Tapatalk Pro