Power running boards

[Pull Ya]

He left em down ... Not the car wash’s fault ... That’s also why they tell you to take your antenna off ... Can’t blame somebody else for your mistake


Sent from my iPhone using Tapatalk

Your right but people still try to do it every day. (This is not directed at the OP)
Jay

 

[fred123467]

I have amp on my truck and those are not it. They look like they are the bestop brand, probably the 75138-15

Definitely not amp. Definitely a factory button. Contacted amp and they do not manufacture the factory ram boards for this model. Not the car washes fauly, never said it was. It was mine. As stated above I'm trying to find a more cost efficient solution.

I'll try contacting Boston next

 

[DodgeDude99]

I have amp on my truck and those are not it. They look like they are the bestop brand, probably the 75138-15

Those aren’t Bestops, at least their arms look nothing like that. Here’s a bestop arm.
Their website only shows up to 2018.

 

[Bliksimstraal]

Definitely not amp. Definitely a factory button. Contacted amp and they do not manufacture the factory ram boards for this model. Not the car washes fauly, never said it was. It was mine. As stated above I'm trying to find a more cost efficient solution.

I'll try contacting Boston next

Fred123467, please let me know when you find out where they come from. Exact same thing happened to my limited. Only, I did not set mine down manually. Only the one side was down for some reason (saw in the car wash video footage). The side that was down was caught up in the washer.

Agreed, very expensive replacement. I have been waiting 3 months already to see if MOPAR will produce a "sub-assembly" for the $1500 replacement.

 

[IowaRick]

Check with your local computer nerds I bet the part could be 3D printed a whole lot cheaper. Set up a run and sell extras on eBay and recover your cost.

 

[kp4243]

Agreed Mopar didn't manufacture them.

 

[slacadjuster]

Recently had a run in at a wash and my running board got snagged. Where can I find this piece without paying an arm and a leg?

View attachment 152962

View attachment 152963

You do realize they're called side steps, and NOT running boards right?? There isn't 1 ounce of wood in them

 

[DodgeDude99]

Recently had a run in at a wash and my running board got snagged. Where can I find this piece without paying an arm and a leg?

Rolling Big Power has power steps out now as well.
Take a look at those to see how those compare.

 

[Bliksimstraal]

Just reviving this thread to find out if anyone has had any luck? I have tried a few local metal fabrication companies. None baring one has even bothered to reply to my quote requests. I even took the time to do a technical drawing of the brackets so that folks could see what the dimensions are.

 

[BOWERSFJ]

A good machine shop can’t charge enough to make it worth their while, and still be affordable for you ... Material minimums, programming and machine setup time ... It’s just not worth it for them


Sent from my iPhone using Tapatalk

 

[bigdodge]

Looking at the RBP steps they look pretty similar to what the Mopar steps are. Someone makes them.

Sent from my Pixel 3 XL using Tapatalk

 

[MotorBoy]

It's hard to say. Your running board looks really a bulk.