Ram 6 bolt conversion any info on fixing abs as they are wanting to see different information?

[jeremyschneider]

 

[Daw14]

Huh ?
More information about your question might help to clarify what the problem is.

 

[jeremyschneider]

I have a 2014 ram i have swapped 2022 ram rebel diffs and suspension into but the abs signals between years is different. So all my traction lights and speedo are inop

 

[62Blazer]

How are the wheel speed sensors currently hooked up? Do you have the 2022 wheel speed sensors still installed and did they plug into the factory vehicle side connectors? Did you install the 2014 wheel speed sensors into the 2022 hubs?
The 2014 and 2022 models show different part numbers for the wheel speed sensors. While the sensors don't really change the signal (they are just reading the tone ring), they could be wired differently or if you mix matched tone rings and sensors they may not be gapped properly.
Also not sure the number of teeth between the two models.
Have you hooked up a scan tool and can read live data to see what the signals look like? What are the specific codes showing?
There is a lot of basic information that is needed before anybody can even start saying what is needed.

 

[jeremyschneider]

All figured out!

 

[Wild one]

All figured out!

Well tell us what you figured out

 

[Daw14]

All figured out!

This forum works best when people share problems and solutions. Then we all gain knowledge.

 

[jeremyschneider]

5 gen front hubs with, 4th gen sensors in the front, and 5th gen rear axles with 4th gen tone wheels and custom sensor mount brackets for 4th gen sensors.

 

[jeremyschneider]

Both 4th and 5th gens have 55 tooth abs tone wheels in the hub but the pick ups are different (same plug just wrong resistance)

 

[DA67Goatman]

Good info. Thanks for sharing.

 

[PdPuNOme]

So the only parts is the 5g front hubs installed into stock 4th gen spindles and the rear 5g axle shafts installed into stock 4th gen axle housing along with swapping tone ring to the 4g? Then modified rear sensor bracket?

 

[jeremyschneider]

I used complete 5th gen rear axle with elocker but 4th gen tone rings, and complete loaded front 5th gen knuckles ( spindles,hubs,and brakes.) I also used the 5th gen front diff only because of ratio