Vent and Accessory light issues

[05With35s]

I recently bought my 2005 ram and wanted to hook up the subs that came with the truck. It has the stock radio in it with the adaptorm and i couldnt figure out how to do it But now my air control lights for night dont work and im thinking i bumped something. I am very new to all this stuff so i was hoping i could jump on here and see if anyone knows something about this before i spend some money on getting it fixed!

 

[Mega-Hemi]

You're pretty much just gonna have to go back over anything you touched and make sure the connections are all tight.

 

[05With35s]

You're pretty much just gonna have to go back over anything you touched and make sure the connections are all tight.

I tried that and made sure the connectors were all snug, but still nothing? Im so confused, and i really dont have the money to have a dealer look at it lol

 

[bigbadram1500]

Wish I could help, but I have limited knowledge in the electrical area. Wanted to welcome you to the forum tho.

 

[quietpeen]

welcome to RamForum. there are harnesses on the back of the bezel, when you retraced your steps did you make sure those harnesses are plugged in properly?

 

[wermbang]

Also check the fuses, may have touched something and blown one. I did it when I installed the LEDs in mine.

 

[BlackedOutHemi]

I know on my truck. All interior lights are run off of one fuse. So all of your lights would be out if it was a fuse.


Sent from my iPhone using Tapatalk

 

[HemiBabe]

Hope ya get it squared away

 

[05With35s]

I know on my truck. All interior lights are run off of one fuse. So all of your lights would be out if it was a fuse.


Sent from my iPhone using Tapatalk

Yea thats what i was thinking that they all run on one fuse. And the only lights out are for the vent speed, where it blows (like feet and face), and the 4 wheel drive knob

 

[BlackedOutHemi]

Maybe the actual light is burnt out?

 

[Bad Hazard]

Maybe the actual light is burnt out?

This.


I had this happen on my 04 cummins. I could hit the dash and the lights would come on, very very dim though. Switched them out and bam good as new. Now would be a good time to do a custom blue/red light interior. Cost about 35$ on your truck

 

[05With35s]

Maybe the actual light is burnt out?

How do i get to the lights? and would i be able to tell if there burnt out?

 

[05With35s]

Maybe the actual light is burnt out?

How do i get to the lights? and would i be able to tell if there burnt?

 

[BlackedOutHemi]

Sorry. Pull the dash, unscrew the HVAC controls from the dash bezel, and then you should be able to use small screwdrivers or something of the sort to pop the back of the controls off. Then the lights should be attainable.

 

[iceman]

check the fuse mine has one fuse to run overhead light and one to run instrument lights