blu3s94
Senior Member
- Joined
- May 29, 2015
- Posts
- 113
- Reaction score
- 21
- Ram Year
- 2015
- Engine
- Hemi 5.7
So Installed the zones yesterday, currently getting an alignment right now. My local auto parts store only had a needle style torque wrench. It was very difficult to see if I torqued the arms right, if anything I think I went too far. Is it ok to back them off and retorque with a clicker AFTER THE ALIGNMENT has been done??? I'm having the alignment done right now, planning to just buy a clicker torque after this.
Also the zones are extremely close to the strut tower, like 1/8" close. I offset the ball joints to the rear and longer arm is toward the front of vehicle. Can someone else confirm that's correct and theres are also close to strut tower frame?? Thank you!!
Sent from my SM-G960U using Tapatalk
Also the zones are extremely close to the strut tower, like 1/8" close. I offset the ball joints to the rear and longer arm is toward the front of vehicle. Can someone else confirm that's correct and theres are also close to strut tower frame?? Thank you!!
Sent from my SM-G960U using Tapatalk