Al Handy
Member
As a side bar, the various replacement bumpers weigh in between 200 and 400 pounds, what are "yous guys" doing to keep the front end level or at stock height? Pucks? New Springs? Wonder if ACOS are available for the Rams?
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I was worried about that prior to ARB install... so I bought the +1.5” Thuren springs. But after taking the winch cradle out and swapping to a synthetic winch line, I was actually tail-low... so I then added 1” spacers in rear to level it out.
As a side bar, the various replacement bumpers weigh in between 200 and 400 pounds, what are "yous guys" doing to keep the front end level or at stock height? Pucks? New Springs? Wonder if ACOS are available for the Rams?
I cant imagine the cable weighing much more than 30 pounds or something. That would have less effect than having a passenger riding with you. It made the tail end low?!
I know this is an old thread. But, did the 16.5 Winch fit in the PW Cradle ?I switched out all my PW winches to 16.5 warns. Even my second gens have that size winch
What do you do with the front bumper sensors?I’m going out on a limb and ordering the ranch hand full replacement winch bumper, I’ll report back with any fitment issues etc. once it’s installed.
The ranch hand has holes in it for the sensors and factory fog lights already which is nice. I’ll post back with any issues though once it arrives and install begins.What do you do with the front bumper sensors?
No. Has to be mounted foot forward. Factory one does not, if I remember correctly. I know it is wider. Which also caused the mounts to me moved forward.I know this is an old thread. But, did the 16.5 Winch fit in the PW Cradle ?
Thanks for the Info.No. Has to be mounted foot forward. Factory one does not, if I remember correctly. I know it is wider. Which also caused the mounts to me moved forward.
No problemThanks for the Info.
So you don't have to relocate the sensors?The ranch hand has holes in it for the sensors and factory fog lights already which is nice. I’ll post back with any issues though once it arrives and install begins.