69GWC
Power Wagon
- Joined
- Oct 1, 2015
- Posts
- 5,387
- Reaction score
- 6,952
- Location
- Spring hill, Kansas
- Ram Year
- 2022 Power Wagon
- Engine
- 6.4 Hemi, 8sp
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Beautiful rig!Had to give it a bath
I would take a measurement first. I'm not sure what the gate-to-plate cleareance is when the gate is down for your '22 but the '19 does not have much clearance. Some have a little more than others depending on assembly.Hmm,
I NEED VLED's LICENSE PLATE BRACKET LED!!!
View attachment 505321
just like Bobbies
more is better.
SENSORS: I really did mean Bobbies, you know, those English Cops without guns.
. Not my fault you got a dirty Mind.
It positively absolutely for darn sure hit the VLED Light.I would take a measurement first. I'm not sure what the gate-to-plate cleareance is when the gate is down for your '22 but the '19 does not have much clearance. Some have a little more than others depending on assembly.
I put a very low profile plate frame on and noticed that the gate barely cleared it when down (I could pass a piece of paper through the gap but not the width of a McDonald's takeout bag) so I took it off as that was too close for comfort for me.
I had been eyeing the VLED bracket until I noticed the gap issue.
Oh I gotta check out those Putco Door Sill Guards. I tried the Weathertech ones and they did not fit at all. I'm a big Weathertech fan so I was disappointed with that.Had my BedRug installed.
This is how it actually looks to the human eye.
View attachment 506340
Also had them install a couple of 30inch LED light strips, connected to an On-Off Switch.
Camera makes the front appear much darker than it actually looks to me.
View attachment 506342
NOTE: Cameras can only see 5 Steps of Light, Humans can see 12.
Pretty happy with the Install.
Everything looks snug & Tight.
The Rug still has to lay down a bit but that's just from packaging.
Can see the fold lines still but those will come out, over time.
Closing the tailgate takes some Oooph, what with the bedrug and the tailgate seal.
Also had them install some Putco Door Sill Guards.
Not my Truck but this is how they look.
My Picture turned out horrible.
View attachment 506343
Can't really see it, not nearly like the Companies picture shown here.
Got to really look hard to notice it's there.
Just black 3m Tape but, hopefully, it will keep my door sill paint from wearing off, like it did in my last two trucks.
Figure replacing that 3M tape will be much cheaper then painting the Sills.
I do not want a patch of gray primer showing up because i wore the paint out on this black truck.
Primer popping up on my red trucks was bad enough.
Beautiful looking rigs guys!!