BT module should be something, but it's main board specific and your the only one I know with a PX6.
If you can connect your phone to Bluetooth (and it works for phone and media) you're good.
If I'm not mistaken the Alpine system gets audio over the CANBUS. It could be that you need a different adapter but I think it's already communicating so it's not that...
Sent from my HTC U11 using Tapatalk
I ended up making a list of all the things that don't work and reopened the ticket that Dylan so kindly closed.
The OEM stereo is back in for now.
Things to address:
1. FAN harness/cable needed
2. Determine cause of Alpine speaker system not functioning correctly - only front speakers work and the sub. When fader is moved to front, front speakers go mute. No discernible audio from rear at all.
3. Suspension controls are in the software but items do not do anything. EX: Jack mode is suppose to temporarily disable the suspension so that the vehicle can be jacked up without the suspension trying to compensate. When I activate this item nothing happens. On the OEM the EVIC shows a message that the suspension is disabled. The transport mode is suppose to lower the truck to the lowest setting so that it can be tied down on a flat bed truck. Again nothing happens and this setting actually reverts when ON is selected immediately back to OFF. Again on the OEM this works and the EVIC shows that the truck is lowered to the Entry/Exit mode.
4. The break controller is not listed in the available settings at all.
5. None of the steering wheel reassignments work. The steering wheel buttons I have all are assigned to the OEM functions, however neither the 'Wheel setting' nor the 'Touch Key' menus allow me to redesignate functions to my liking - may be user error. I select the function on the software first and then attempt to long press the physical button I like to assign - nothing happens.
The park sensor thing was my bad. My recollection was that the park sensor distance was shown under the backup camera, but is actually an EVIC display. I checked this and it's working fine with the PX6.
Wish me luck with these guys tomorrow. I'll go the direct route first of attempting a phone call, but if that doesn't help I will post on FB next.
PS: Their demo video stated that this new unit is BT5 which allows multiple devices to be connected, but given that this is an appliance as SitKneelBend already stated, I am not sure if we ever could utilize it to add a BT OBDII. One thing that I will try is my theory that maybe a powered USB hub and a dedicated USB BT adapter might give that possibility.