2017 Ram 1500 Front and Rear Bilstein 5100 Install with Rear 1" Spacer. WHATS NEEDED?

[DavidRussell]

Ive got front and rear bilstein 5100s.
PN: BIL24-187367 and PN: BIL24-187374

Also have Daystar 1" Rear coil spacer.
PN: KC09116BK

Up front. I can use the Bilstein with it being set to 2.1" lift with the stock coil. Nothing else needed? I am not setting 2.8" to avoid replacing the upper control arm.

In back.. This will make it so I can lift the rear 1" without changing coils right? Or am I mistaken here?

Also, do I need to do anything with bump stop?Need to do anything with break lines or Sway bar? Am I missing anything at all?

Sorry for all the questions I just don't want any surprises.

 

[Mopar1987]

That’s about exactly what I’ve got. I went 2.8 but also put different upper control arms on. Nothing else needed for you front or rear

 

[kurek]

You're going to need either a 21mm crow's foot wrench or the Thuren rear shock nut set.

 

[ram1500rsm]

You’re all set.

 

[osprey ram]

I have 09 set-up w/what you're referring too. only thing I added was air lift 1000 in rear. Wore out rear springs, helps with hauling.

 

[Wild one]

I have 09 set-up w/what you're referring too. only thing I added was air lift 1000 in rear. Wore out rear springs, helps with hauling.

Don't know if you noticed,but this thread is over 4 years old