Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Toyed with this idea...
2X 7.5inch 18W Flush Mount Spot LED Work Light Bar Driving Off Road ATV SUV JEEP | eBay
Each has about the same output as a LED pod
flush mounted LEDs in the tow hook area
it has the fog light push button switch on the headlight knob. And, the indicator light shows on the cluster when pressed on.
The fog light switch would be inside the round auto/off/parking/on switch. The push button switch you're looking at is for your cargo lamp. It took me a week to figure out what I was turning on
Oh, well you're that far ahead on the install.Maybe I didn't write that well enough. It is the push button inside the center of the headlight knob. My cargo light is bottom right beside the dash/ overhead light dimmer.
Yeah,. It sounds like the foglight sales code may already be loaded. Did you buy the truck used? (Was it in a wreck or the bumper replaced at some point?)Maybe I didn't write that well enough. It is the push button inside the center of the headlight knob. My cargo light is bottom right beside the dash/ overhead light dimmer.
Thanks for your reply. Yes, I did buy the truck used. It was previously owned by the Diesel Tech the local Ram Dealership. He traded it to get a 3500 and 5th wheel. He took very good care of the truck. I have no reason to believe the bumper has been changed.Yeah,. It sounds like the foglight sales code may already be loaded. Did you buy the truck used? (Was it in a wreck or the bumper replaced at some point?)
Maybe you already have the 4 pin connector and wiring behind the lower left side of the bumper...
See the instruction sheet linked in the earlier posts for location and picture of the connector.
M² Mods.