Micchi
Senior Member
Wondering if the lifter is bad
Sent from my SM-G920P using Tapatalk
Sent from my SM-G920P using Tapatalk
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Wondering if the lifter is bad
Sent from my SM-G920P using Tapatalk
The rocker arm isn't loose though. I figured if the lifter was bad I should have some play in the arm or pushrod.Could be collapsed as well. Hopefully not a worn cam lobe
Sent from my iPhone using Tapatalk
The rocker arm isn't loose though. I figured if the lifter was bad I should have some play in the arm or pushrod.
Sent from my SM-G920P using Tapatalk
This is my first time messing around in an engine. Swapped the pushrod's and got the same result. So I really think it may be the lifter.True. If it was collapsed the push rod should be able to wiggle at least. But the fact that it does come up some but not enough to really open the valve. Maybe try removing the rocker and turn the motor by hand and see how much the lifter/pushrod comes up. Just an idea. I’ve never heard of a stuck valve but I’m also still learning about motors. I would think if the push rod goes to full lift with no pressure may be the litter or possibly stuck/bent valve not allowing full lift. If still no lift then I would assume cam lobe
Sent from my iPhone using Tapatalk
This is my first time messing around in an engine. Swapped the pushrod's and got the same result. So I really think it may be the lifter.
Sent from my SM-G920P using Tapatalk
Yes I did. Well guess I need to add that to the list of things to fix.Did you separate the trans from the motor when transferring to the newer frame? If so I would assume input shaft seal from being disturbed during the separation and reinstall.
Sent from my iPhone using Tapatalk
Yes I did. Well guess I need to add that to the list of things to fix.
Sent from my SM-G920P using Tapatalk
Not sure what else would be leaking but now I get to drop the trans to find out.Not for certain that it is that. Just something else to keep in mind. I got lucky when I did the clutch in my car because it was a common fail point on that make of vehicle
Sent from my iPhone using Tapatalk
I'm going to rotate it again but I couldn't see anything when I lookedhave you checked the cam to see if it is damaged? i wouldn't be surprised if something like that could have wiped out a cam lobe
Ok well crap, didn't look at the whole thing when I first took a look. But somehow a lobe for cylinder 1 and 2 are done for. Not sure how I managed to do this but looks like I'll be getting that cam I was thinking aboutI'm going to rotate it again but I couldn't see anything when I looked
Sent from my SM-G920P using Tapatalk