Gearshift cable tightening?

[EastWestHemi]

Anyone know procedure to tighten it up some. My transmission started to get some vibration after installing the aftermarket pan at speeds between 50-70mph. When I put downward pressure on the shift lever coming out of the steering column the vibration goes away. Leads me to think if I tighten it a little the sound might go away.

the sound is just more annoying than anything else. Transmission has been very good for the 20k I have on it.

 

[mtnrider]

There is no shift cable, it's all electronic now. You move the shift lever and it sends a signal down to a actuator on the transmission to make the shift. There is no physical connection between the lever and transmission.


.

 

[EastWestHemi]

Not mine, the cable runs into the firewall and down to the transmission to the drivers side of the transmission. I have the tradesman with the old style shifter lever coming out of steering column. There must be a procedure to tighten it if it had stretch a little bit.

 

[SRich2015]

White clip with Green mark is the cable adjustment. Pull the clip outward and make sure the lever is fully engaged in park!!!

 

[EastWestHemi]

I’m going to...
1. Set parking brake
2. Shift into park
3. Pull clip

after that.... do you pull the plastic arm off? How does it adjust? Is it on a threading system where you spin it to tighten and loosen it?