Replacement Fold Flat cutout trim

[Indynick]

I just received a tracking number from Patricks. I'll update this thread after I receive the pieces, sometime early next week.

 

[Indynick]

I received the trim pieces today. I will post some pictures after I install them.

 

[Indynick]

I installed one side, but a storm kept me from doing the other. I had to ream out one of the holes in the floor, to get the two halfs to fit. No big deal, as the floor is made of fiberglass. I will try to get the other one done tomorrow.

 

[Indynick]

Sorry , it took so long to get back. I was planning on replacing the second set that Patrick sent me, but I have been unable to figure out how to get the undamaged factory ones off. I don't want to damage the unbroken ones , so I think I'll leave them there for now. If anyone knows an easy way to get the factory ones off without breaking them , please let me know.

I started this whole process by sending him a PM. It took a while for him to respond , but it is a part-time job that he's doing with his daughter.

I am very happy with the part that patricks created.

 

[04fxdwgi]

If you are replacing the breaking prone OEM ones, why would you want to save it?

The OEM one still remaining can be popped off with a screw driver but will be ready for the trash can when done.. That's how I did mine. I also screwed on from the back so the screw heads don't show. Took all of 15 minutes start to finish.