Problem with a big Socket

[alanbike]

Hi everybody
My problem is with the big socket under the chassis at the driver's feet!
I no longer have a reversing camera or reversing lights and I have a big park sense alarm on the Miles screen.
I have one or more faulty rear bumper sensors but I never had this big alarm on my screen behind the wheel!
It all started with the gear change wheel which no longer worked, I then disconnected the battery and opened this big connector to clean it, it worked but I had several error codes, I opened it again, and now I only have three problems, but what to do? open it again? I really want to solder the wires and remove this connector !!! I hope the traduction is good

Sommes pictures of this socket

Sorry for my English

 

[04fxdwgi]

Check to ensure pin(s) are not pushed back into the socket / not seated properly.

Have seen multiple times a pin push out and losing connection

 

[alanbike]

Thank you , it is what I think me to .

 

[NETim]

Maybe clean the contacts after verifying that they’re mechanically sound?


https://caig.com/deoxit-d-series/

 

[alanbike]

I have already done it, opened the socket, cleaned, inspected and applied KF F2 contact cleaner, I have errors which have disappeared but some have remained and I have the locking lever which no longer holds very well so I think that the socket no longer closes really well. I made an appointment at a garage to make the continuity in the socket and close it securely.

 

[Wild one]

I have already done it, opened the socket, cleaned, inspected and applied KF F2 contact cleaner, I have errors which have disappeared but some have remained and I have the locking lever which no longer holds very well so I think that the socket no longer closes really well. I made an appointment at a garage to make the continuity in the socket and close it securely.

Creative use of some zipties will bypass the locking lever as far as holding the connector together

 

[NETim]

If you go the zip tie route, a zip tie gun is worth the investment. They cinch the tie down nice n tight and cut it off flush. Very handy tool IMHO.

https://www.amazon.com/s?k=Zip+tie+...&sprefix=zip+tie+gun,aps,165&ref=nb_sb_noss_1

 

[alanbike]

It's exactly what I want to do

 

[alanbike]

Hello, the garage where I took my Ram will remove this connector and solder the wires with silver, plus thermo sheath!

 

[alanbike]

All my problems are solved by removing this connection using silver soldering.
thank you all

 

[Mojo88]

All my problems are solved by removing this connection using silver soldering.
thank you all

Nice! Did they actually find the problem?

 

[alanbike]

Nice! Did they actually find the problem?

Yes it was a bad contact in this socket . this socket is very often the source of many electronic problems on Rams