crazykid1994
Senior Member
Alright so going against all my original ideas here but I’m contemplating a 4” lift kit and ordering new fox front coilovers at the same time and going to 1” over for a 5” lift front and purchasing 3” rear gladiator springs. I may do the 2” lift blocks and keep my eibach springs for a bit though. Possibly zone? If I go that route I’m debating a rear box kit from procomp to drop the rear control arms instead of the relocation kit that the zone kit uses. Part of the reason I’m thinking about this is because I am currently at 3” front 1” rear and after off-roading last time I did bottom out a few times plus I’m trying to gain some down travel back by using less preload. Plus that should be a lot easier on my cv axles too. Then I’ll build true sliders and a full belly skid. Already have a design in mind.
Attachments
Last edited: