- Joined
- Jan 8, 2015
- Posts
- 9,103
- Reaction score
- 4,794
- Location
- St. Louis
- Ram Year
- 2014
- Engine
- 3.6 Pentastar
Try this...Any ideas on the "device not supported" message I'm getting everytime the radio powers up?
I updated from a factory 5.0 to a UAQ. Bought it new from Benny. Also did the 4 to 7 spd blower conversion as well as the single zone auto temp conversion. I added the sun sensor for atc harness and the 4 pin sun sensor. Everything went well except two issues.
I get a "device not supported" window everytime the radio powers up. It doesn't go away until you click ok. First I thought it was because I haven't installed the updated usb hub. So I did that tonight and no change. I still get the message. No phones paired. Nothing connected to the usb ports or aux. No fault codes in the radio either. Kinda disappointing after the money spent to get an in your face issue everytime the radio powers up. And you can't find out what device it's referring to either.
The other issue I have is a fault code in the HVAC. I don't recall the code but it's for the right side blend motor. It's setup for single zone ATC, so it shouldn't look for a passenger side blend motor. Fault only goes away if I revert back to single zone manual. Is this an expected fault that everyone gets? Would it effect the system operation? Any way to eliminate the fault?
View attachment 244644
View attachment 244645
View attachment 244646 View attachment 244647 View attachment 244648
Specs
2018 Ram 3500 tradesman. Diesel. Factory back up camera. Factory 5.0 and sat radio. Factory rear parksense.
Harnesses I bought from mp grimm. Everything else Chrysler, Benny.
Thanks,
Earl
https://www.ramforum.com/index.php?posts/2495436
Sent from my HTC U11 using Tapatalk