Ram 2500 alignment help

[Mattera350]

long story short had a 6.5” Cummins lift installed shop half a$$ed it stole hardware only had 1 bolt holding
Drops to frame a week later I have another shop fix all the issues now
I’m 3 alignment shops later trying to get a alignment but having issues with only driver side caster lift measures about 7.5” front 5.5” rear due to
It being a gas motor

 

[Mattera350]

Also how bad of a job to change a tcase half don’t wanna pay 1800 to a dealer to replace a tcase half. The shop who did the lift dropped the case n dented right where the out put seal is.

 

[muddy12]

With a solid front axle, you really can’t adjust the left and right caster angles separately. The entire axle has to rotate as a unit. Unless you want to have the C’s cut ant turned, it going to be a compromise between your caster and pinion angles.


Sent from my iPhone using Tapatalk

 

[Redheadhunter21]

I would drop your toe down to zero and try to balance your caster a little better but not worry so much about raising up the drivers side caster angle. A great reference for alignments on these trucks is Thuren Fabrication