5.7

  1. Slow_04ram

    Has anyone swapped to an electric water pump

    Hello I have a 2004 5.7 building it for boost but want all the right accessories to gain a little more at the moment before my build. I have been searching for an electric water pump but cannot really find anything that bolts on without to much fabrication any suggestions
  2. M

    Fuel rail end broke off in quick connect

    3rd gen hemi 5.7 with a stupid problem So I have the worst luck I swear. Had my fuel line removal tool. Went in ok. Barely pulled and the darn thing broke off immediately in the quick connect. Tried putting the tool back in and the broken fuel rail line must be severely rusted to the back of it...
  3. M

    Weird clip Found between cylinder head and block

    I found this weird clip resting between the cylinder head and block on the passenger side when doing the head gaskets. I don't recognize it but wondering if anyone else does. If anyone is curious yes someone was in it before at some point because I found a few broken studs on the exhaust...
  4. LoganWebb

    5.7L CAI on a 4.7L?

    I’ve got a 07’ ram 1500 with the 4.7. Recently fell in love with the S&B CAI’s and have been looking into them for a while. However, it seems they only make the kit for the 5.7L. I’ve gone through several forums trying to figure out if it would fit and most forums have been people just throwing...
  5. T

    Looking for a 5.7 hemi eagle in northern az

    Anybody have a block, long block or complete 5.7 hemi eagle in northern even Arizona
  6. G

    2013 ram 5.7 backfiring, and throwinf 25 codes

    I bought a 2013 ram 1500 with the 5.7, engine had bad lifter,cam and 1 bad piston and knocked but still ran. It had engine codes for the electronic throttle, trailer brakes, low battery voltage and multiple missfire. So I put in a reman engine, and now the truck no longer knocks. But It still...
  7. Moparoadrunner

    Lost some coolant, would like some advice please.

    5.7 hemi Couple of days ago i had a leak from the top radiator hose - loose clamp, in the overflow tank the coolant wend down just under the low cold fill line when hot. Coolant temp was normal. Next morning added coolant and put cap back on before starting engine, drove around , no leaks...
  8. B

    2012 Ram (1500 5.7 with MDS, 107k miles) Crank, Cam, and other questions

    Hello, hopefully this post has enough info to answer a few questions I have. Background; the vehicle is new to me and had a severe 'tick' when purchased (single tick at engine speed, same tune at all temps and all rpm ranges). Figured I might get away with just a simple exhaust manifold bolt...
  9. J

    Shorties quieter than stock?

    Hi, I need some help and I hope there might be an explanation. I just got some BBK shorties installed (plz dont bash me about BBK I know they arnt the best and getting shorties, I had broken bolts) and they seemed to make my exhaust quieter? I had Flowmaster super 10 muffler and stock manifolds...
  10. H

    Pentastar vs Hemi, which should you choose?

    When I was in the market for a 4th Gen Ram 1500 Classic, I was pretty torn about whether to go with the Pentastar V6, or the Hemi. It can be difficult to make the right decision with just a short test drive from the dealer. Now that I’ve owned both, I wanted to give a detailed account of the...
  11. M

    Lifter Failure after non mds swap.

    Hello Fellas, Recently purchase a Texas Speed Performance OE Non MDS Cam Kit and got it swapped out at a local shop. 3 days after driving the truck, i got a rough idle and a cylinder 2 misfire code came up. Also one of the lifters got really noisy which im guessing is a failure because of the...
  12. K

    P1DBD

    Hi every one I have a 2015 Ram 1500 5.7 with an 8 speed. About 6 months ago I replaced the fuel sending unit because the original fuel level sensor went out on me. Shortly after I got a new code pop up P0463 if I remember right, so I replaced the fuel pressure sensor. About 3 months go by and no...
  13. rgallina25

    86 d150 '03 5.7 help

    Hey all, Newbie here.. I've recently picked up an '86 d150 this past weekend. Body/frame are both solid, no motor or trans. I have an '03 parts truck I purchased for another project awhile back that is still complete minus a few body parts. Runs and drives, was just hit in the front. I'd really...
  14. O

    Exhaust manifold hole pattern

    Does anyone have the hole pattern dimensions for the exhaust manifold bolts on a 2014 5.7 Hemi? I want to make a template for removing broken bolts. :)
  15. H

    5.7 Valve Spring Compressor Tool

    I am hoping that someone has a lead to someone who actively has one I can buy or someone who makes these. The last one I bought from a forum broke about 2 springs in. looking for a durable one to take the spring off with the heads on. Any insight would be amazing. thanks.
  16. MartyZ

    Pulled the Trigger on ARH headers, ARP Studs, Remflex Gaskets.

    So I finally pulled the trigger. Ordered the headers from Moe's, ARP Studs (140-1101) and Remflex Gaskets (6022) from Amazon. I know I have broken studs, where they broke and how many is still unknown at this point but I figured I would start a write up on how to repair them. I will more...
  17. T

    2014 Ram Bighorn 4x4 5.7 8-speed Transmission?

    To start, my truck has 104000 miles. I drive it every day and once or twice a year it goes off road during hunting season and maybe once or twice a year on an off road joyride. Nothing crazy. Mostly 2-tracks and dirt roads. Recently I went on a joyride down some dirt 2-tracks and a pretty bumpy...
    • TheShiv
    • Thread
    • 1500 2014 4x4 5.7 8-speed bighorn ram sluggish squishy transmission
    • Replies: 15
    • Forum: Engine & Performance
  18. AZGreen

    Badlands Apex Control Box Relocation Ideas?

    Howdy, y’all. I recently installed the Vice Designs Hidden Winch Mount and a Badlands Apex 12K (synthetic) winch on my 2017 5.7 Lone Star 1500. Everything looks great, but I can’t seem to find a good control box relocation spot. It seems that this control box is larger than the Zeon 12S’...
  19. G

    MDS Shutter and shake first and second

    Hello everyone!! I am back again with more testing since my last post. To recap, I drive a 2014 1500 with the 5.7 and zf 8hp70 , I run a 93 octane tune but drive mostly with my MDS on(not full time active). About 4 months ago shortly after I had acquired the tune I noticed a slip or shake when...
  20. N

    4th gen ram mods (new)

    hello all I know there’s 100s of posts on this but can anyone give me some tips to mod my truck I’ve got a brand new 4th gen (classic) 5.7l crew cab I’ve already done the ez tailgate mod and the front stone guard. I’d like to keep stock wheels they are the black night edition ones can anyone...
  21. X

    2013 RAM 1500 Losing power after Warm up

    Hi guys, I'm running into an issues for the past few days where I'll crank my truck up and let it idle and warm up for around 15-20 minutes in the morning before work. Water temp is good, Oil temp isnt too bad and even trans gets a little radiated heat into it. The problem is after taking off...
  22. B

    Bad MDS Solenoid Okay?

    Hi all, I am considering replacing my 2nd gen ram with a 3rd gen Hemi. I have found a gentleman on Facebook marketplace who has a 2007 SLT for sale that he says has a bad MDS solenoid. Should I run away as fast as I can? or is this not a very big deal? The owner says he has the truck set to...
  23. 2

    Lift/leveling kit suggestions 2wd 2500 gasser

    I have a 2013 2500 5.7 2wd. Nothing fancy but she pulls the boat and she's been good to me. Im having difficulty finding a lift kit that fits my truck. I searched this site but can't seem to find any thing for my particular truck. Any help or suggestions would be much appreciated
  24. 2

    Lift/leveling kit suggestions 2wd 2500 gasser

    I have a 2013 2500 5.7. Nothing fancy but she's been good to me. Im having difficulty finding a lift kit that fits my truck. Any help or suggestions would be much appreciated
  25. 2

    2012 ram 1500 HELP

    Hey guys, I’ve had my ram for 6 years now. Had my ups and downs with it. It’s a 2012 ram 1500 with a 5.7 hemi. 225,000 kms on it. New lifters and camshaft at 200,000 kms. Spent a lot of money on repairs. Seems like it’s just one thing after another with this truck. Seems to just be slowing down...

Latest posts

Members online

Total: 8,881 (members: 34, guests: 8,847)
Robots: 1,783

Forum statistics

Threads
211,598
Posts
3,068,856
Members
172,310
Latest member
jimn
Back
Top