hello, first post here. tried to find answers elsewhere to no avail.
so i've got an 02 ram 1500 quad cab 2wd 6.3' bed. it needs new tires. the biggest factor in my situation is some serious budget constraints, please keep that in mind as we go forward. stock is 245/70/17 on 17x7 ET25, previous...
I got a 1997 Ram early last year. Since then, I've driven just over 2000 miles and have had 4 power steering pumps die.
Pump 1 - Original (probably). Died before doing anything to power steering
Pump 2 - Autozone remanufactured. Died after about a month while on a trip. Sounded terrible...
Today I replaced the steering shaft joint due to there being play in the steering. After I replaced the parts and went to test drive the truck. As I was pulling out of the drive I turned the wheels and heard a squeak and then snap and my airbag light, esp bas light, and traction control light...
So i just purchased two second gens. a 01 1500 5.9 lifted with 35's and an 02 2500 5.9 stock. Im having this issue with the 1500 where if the wheel is full locked to the left, the truck struggles to move. Turning to right isnt so bad but I noticed the left front tire is much closer to the fender...
2007 Ram 2500 4x4 5.9 diesel: I noticed a rough ride starting on a trip a couple of months ago and ended up putting new shocks all around and a new stabilizer bar on. I am still getting a rough ride; coil springs are good, leaf springs good. Recently aligned, 1 year on tires, 95K mileage. Any...
Hows it going everyone. Recently over the past few weeks my steering has become awful. I just want to start by saying I'm on a 6" lift and 35" tires. The first 1/8th of turning the steering wheel in either direction results in almost taking my whole body weight to turn the wheel then as I...
Ok I was replacing my rack and pinion on my 2007 ram 1500 2wd and didn't have my steering column connected to the rack and pinion and I took a break and my buddy got in and was turning steering wheel so I guessed at lining it up and I'm off I believe I can hear the wires or tape/wires for the...
So after doing some searching around on here I can not see to find any information about installing an aftermarket steering wheel on my ram. Anyone have an information at all?
Hello, I've been rebuilding my 2nd gen Dodge Ram dash (1997), which was cracking and splitting horribly since 2015. I took my steering column off in order to roll the dash more forward, and in doing so had some parts that needed to be replaced. I made this video so others might have an easier...
Let me start off by saying I have all new upper control arms and lower ball joints, tie rod ends, and wheel hub/bearings. Within the past week and a half my 1500 reg cab 2wd has developed a popping noise while turning the wheels and now it's pretty loud. It happens sitting still and moving but...
My rack and pinion is leaking where the steering column goes into the steering rack. I was wondering if they can replace the seal or I have to buy a new rack. Please help any info is greatly appreciated. I really don’t want to spend the $1500 or whatever it costs for a new one but I will do what...
So I am in the midst of building a prerunner and I am worried about the air bags being a little too sensitive and going off when I am off-roading. Is there a way I could straight up just disable them? I know this becomes a safety issue but this truck never sees the road anymore, I trailer it...
I'll try to give you the details without going crazy here...
There is a TL;DR at the end.
I know this is a novel at this point, but my stress and frustration are high enough that I'd rather y'all have all the details than be missing anything I didn't mention. For all I know, I'm overlooking...
I have installed a BDS level, truck is 4wd. My first 2500, have had 1500's previously...
The question is, when turning hard in 4wd, steering "fights back" makes it difficult to turn in the snow.
Is this just a straight axle issue, do i need to change a component since i leveled it, or is there...
Hello, I am needing to replace tie rod ends and balls joints, among many other things.
I am looking for anyone who has experience and opinion on the Synergy products.
I'm thinking of getting the Synergy HD steering/drag link kit, to replace the OE.
I do have a 2008 Ram 2500 5.7L 4x4, it looks...
I'm in the mechanical process of fixing up my 1988 w100. So far I've replaced the ujoints at the axles (and about to do the pinion side front/rear drive shaft ujoints), front brake lines/rotors/calipers, new drums/shoes, valve cover gaskets, plugs, battery, front/rear diff fluid, and gas tank...
I have just purchase a rolled 2003 1500 parts truck so I can put the low mileage 5.7 hemi into my 2003 2500. I understand the major differences (frame, axles, suspension, ride height and quality), but my question is, what are some of the smaller mechanical things you might not think about...
What up everybody? I’m new here, I just bought my first Dodge truck at an auction a couple weeks ago, it’s a 1992 Ram D150 5.2 318 v8 regular cab 2wd. Anyways.. When I got it home and noticed it was not turning left very much at all, and when I turn to the right the wheel turns wayyy too much...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.