Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
@HTXRamExp
Also I didn’t re wire the door speaker just the dash. As I don’t know how the doors can be done without some serious gutting of the truck there is a computer module and huge metal plate and the dash blocking the area where the wires go through the rubber grommet. So a set of the speakers that was ran parallel technically is disconnected the dash speakers got rewired and the door speakers are on the same original parallel feed with the dash which are now “disconnected” and re wired. How the hell did you guys rewire the door speakers???I don’t see how you would acccess the rubber grommets without serious work.
@HTXRamExp
So you connected new wires to amp1 of the output harness and ran those to the dash speakers. And connected the OEM output speaker wires going to the door speakeR
exactly! Did you guys use a L2C or anything or just the amp to the radio like in your pics
How many cycles we talking? Yea so I literally did the exact same thing as you leave backs factory with a sub installed. Only difference being how I only re wired the tweeters. I tried the default radio reset on settings didn’t make it work. Maybe since I got the 2020 5th gen it changes something...When I get home from work I’ll try the fuse reset. Near the engine I hope to God this works other wise I don’t really know what to do other then uninstall and return it all. Thanks so much for all the help. Really appreciate it my man.Just the amp and radio, with the radio detect button selected on the amp.
Sent from my iPhone using Tapatalk
Yes one speaker per channel the rear speakers aren’t connected at all.did you set radio flat, and ONLY have the 4 speakers hooked up during auto EQ setup?
On the KEY, do you have one speaker per channel hooked up, and everything else unpluged ? Are you sure each channel of the amp is at 4 ohm?
Yes one speaker per channel the rear speakers aren’t connected at all.
Auto EQ set up? I plugged everything in and it’s powering the speakers that are connected to the amp but when I turn on the radio it doesn’t play any sound except through the rear speakers which aren’t connected to the amp.Each speaker connected is 4ohm. do I need to do a set up before it plays any sound at all? I tried the pink noise button and nothing If so how do I do that? I called kicker they recommended getting the load adder called the kicker kISLOAD2
Iimiter lights will flash on startup then shut off unless theres a problem but power stays on.Ok so mine the limiter lights don’t turn on but the power lights on the other side do. I can’t check my setting until I get home.
Your saying the kisload won’t make any difference?The KISLOAD will trick out the amp, so if it doesn't detect a speaker, it wont. But now, if your running as just a 4 channel amp, you dont neeed auto eq. Only when you biamp.
Wife wanted me to help her with some stuff but I had started to double check all the connections and already found one mistake corrected it. Gonna finish tomorrow double checking and for the in line fuse just pull it out and stick it back in? Also what size fuse did you run for your power for the amp to the battery?I'd verify all your connections both +/- alignment and physical connectors
Verify your dip switches. You'll want fader off, bi-amp on. I think one thing that got me was that unlike all the rest, fader off is switched down, not up.
Then do the radio reset.
You should still get sound out of the speakers before you do the auto EQ. The mic even has a button that lets you toggle between tuned and untuned to hear the difference.
Sent from my iPhone using Tapatalk
Wife wanted me to help her with some stuff but I had started to double check all the connections and already found one mistake corrected it. Gonna finish tomorrow double checking and for the in line fuse just pull it out and stick it back in? Also what size fuse did you run for your power for the amp to the battery?