Don't want a stuck jack hold-down? Replace yours with the 2018+ Pieces

[John Jensen]

No - it is larger than the stocker.
That said, I still have the stocker in the stock position. I didn't really try to install the new one there but I don't think it would fit.

 

[ripping r]

No - it is larger than the stocker.
That said, I still have the stocker in the stock position. I didn't really try to install the new one there but I don't think it would fit.

Well i guess you all have 1500. my 2500 has a different set up.

 

[1999 White C5 Coupe]

The numbers you need are the ones on the left side. Looks like about 5 bucks total for both pieces. Here are the numbers so you can cut and paste.
06508288 AA
06512623AA

Thank you for posting this information and for posting the part numbers.

I purchased the two parts from my dealer and installed them on my son’s 2014 Ram Outdoorsman.

I was careful and soaked the original stud with solvent, but it took an channel lock pliers to remove the original (it did not break).

The new one was very easy to install and I used antiseize on the threads that went through the floor metal.

The new stud requires a 10mm wrench or deep socket.

Thanks again.

 

[tnctx02]

Just got my parts in the mail Monday and will get it installed if stops raining.

 

[HDGoose]

Anti-seize wouldn't work?

 

[LarryA]

Just got my parts in the mail Monday and will get it installed if stops raining.

where did you order from? - I am not wanting to pay shipping that is 3 times the cost of the part...

 

[Panamaximus]

Where to buy parts? Link?

 

[Bigpaul13]

where did you order from? - I am not wanting to pay shipping that is 3 times the cost of the part...

Where to buy parts? Link?

https://www.ramforum.com/threads/all-repair-parts-employee-cost.55658/

Check out all Mopar parts.

 

[Rado]

I got my parts from the dealer, Still cheaper then adding shipping worth a shot checking them out